/dev/ada0 smartctl 7.4 2023-08-01 r5530 [FreeBSD 13.2-RELEASE amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Momentus 5400.2 Device Model: ST9100824AS Serial Number: -- Firmware Version: 7.24 User Capacity: 100,030,242,816 bytes [100 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database 7.3/5528 ATA Version is: ATA/ATAPI-7 (minor revision not indicated) Local Time is: Sat Nov 18 10:56:54 2023 SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Unavailable === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 426) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. No General Purpose Logging support. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 63) minutes. SCT capabilities: (0x0001) SCT Status supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 118 094 006 - 171836650 3 Spin_Up_Time -O---- 095 094 000 - 0 4 Start_Stop_Count PO--CK 089 089 020 - 11654 5 Reallocated_Sector_Ct PO--CK 100 100 036 - 0 7 Seek_Error_Rate POSR-- 087 060 030 - 538057046 9 Power_On_Hours -O--CK 087 087 000 - 12210 10 Spin_Retry_Count PO--C- 100 100 034 - 0 12 Power_Cycle_Count PO--CK 091 091 020 - 9762 187 Reported_Uncorrect -O--CK 001 001 000 - 125 189 High_Fly_Writes -O-RCK 072 072 000 - 28 190 Airflow_Temperature_Cel -O---K 067 046 045 - 33 (Min/Max 33/35) 192 Power-Off_Retract_Count -O--CK 098 098 000 - 4175 193 Load_Cycle_Count -O--CK 001 001 000 - 286097 194 Temperature_Celsius -O---K 033 054 000 - 33 (0 7 0 0 0) 195 Hardware_ECC_Recovered -O-RC- 069 051 000 - 146632996 197 Current_Pending_Sector -O--C- 100 100 000 - 0 198 Offline_Uncorrectable ----C- 100 100 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate ------ 100 253 000 - 0 202 Data_Address_Mark_Errs -O--CK 100 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory not supported SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 SL R/O 5 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 SL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 SL R/O 1 NCQ Command Error log 0x11 SL R/O 1 SATA Phy Event Counters log 0x20 SL R/O 1 Streaming performance log 0x21 SL R/O 1 Write stream error log 0x22 SL R/O 1 Read stream error log 0x23 SL R/O 1 Delayed sector log 0x80-0x9f SL R/W 16 Host vendor specific log 0xa0 SL VS 1 Device vendor specific log 0xa1 SL VS 20 Device vendor specific log 0xa2 SL VS 101 Device vendor specific log 0xa8 SL VS 20 Device vendor specific log 0xa9 SL VS 1 Device vendor specific log 0xe0 SL R/W 1 SCT Command/Status 0xe1 SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log (GP Log 0x03) not supported SMART Error Log Version: 1 ATA Error Count: 126 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 126 occurred at disk power-on lifetime: 10836 hours (451 days + 12 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 00 00 01 01 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 00 00 01 00 00 00 00 00 02:45:08.379 NOP [Abort queued commands] ec 00 01 01 00 00 a0 00 02:45:08.376 IDENTIFY DEVICE ec 00 01 01 00 00 a0 00 02:45:08.376 IDENTIFY DEVICE ec 00 01 01 00 00 a0 00 02:45:08.365 IDENTIFY DEVICE 00 00 06 00 00 00 00 ff 02:45:08.356 NOP [Abort queued commands] Error 125 occurred at disk power-on lifetime: 2105 hours (87 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 6b c1 eb 41 Error: UNC at LBA = 0x01ebc16b = 32227691 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 67 c1 eb 41 00 00:25:09.296 READ DMA c8 00 01 00 00 00 40 00 00:25:08.329 READ DMA c8 00 01 00 00 00 40 00 00:25:15.928 READ DMA c8 00 01 00 00 00 40 00 00:25:14.936 READ DMA ca 00 10 2f e6 18 4a 00 00:25:14.936 WRITE DMA Error 124 occurred at disk power-on lifetime: 2105 hours (87 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 6b c1 eb 41 Error: UNC at LBA = 0x01ebc16b = 32227691 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 67 c1 eb 41 00 00:25:09.296 READ DMA c8 00 01 00 00 00 40 00 00:25:08.329 READ DMA c8 00 01 00 00 00 40 00 00:25:08.329 READ DMA c8 00 08 79 2e 1e 4a 00 00:25:08.305 READ DMA c8 00 01 00 00 00 40 00 00:25:08.295 READ DMA Error 123 occurred at disk power-on lifetime: 2105 hours (87 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 6b c1 eb 41 Error: UNC at LBA = 0x01ebc16b = 32227691 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 67 c1 eb 41 00 00:25:09.296 READ DMA c8 00 01 00 00 00 40 00 00:25:08.329 READ DMA c8 00 01 00 00 00 40 00 00:25:08.329 READ DMA c8 00 40 37 e6 18 4a 00 00:25:08.305 READ DMA c8 00 01 00 00 00 40 00 00:25:08.295 READ DMA Error 122 occurred at disk power-on lifetime: 2105 hours (87 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 6b c1 eb 41 Error: UNC at LBA = 0x01ebc16b = 32227691 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 67 c1 eb 41 00 00:25:05.007 READ DMA ca 00 08 b7 8b 00 43 00 00:25:05.007 WRITE DMA ca 00 10 27 81 00 43 00 00:25:02.442 WRITE DMA c8 00 01 00 00 00 40 00 00:25:02.441 READ DMA ca 00 08 bf 8b 00 43 00 00:25:02.441 WRITE DMA SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 11623 - # 2 Short offline Completed without error 00% 11622 - # 3 Extended offline Interrupted (host reset) 90% 10309 - # 4 Extended offline Interrupted (host reset) 70% 9817 - # 5 Extended offline Interrupted (host reset) 70% 9814 - # 6 Extended offline Completed without error 00% 9793 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 521 (0x0209) Device State: Active (0) Current Temperature: 33 Celsius Power Cycle Min/Max Temperature: --/ 0 Celsius Lifetime Min/Max Temperature: --/ 0 Celsius SCT Data Table command not supported SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x000a 2 22 Device-to-host register FISes sent due to a COMRESET 0x0001 2 0 Command failed due to ICRC error 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS