/dev/ada0 smartctl 7.3 2022-02-28 r5338 [FreeBSD 13.0-RELEASE-p11 amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Samsung based SSDs Device Model: Samsung SSD 850 EVO 250GB Serial Number: -- LU WWN Device Id: 5 002538 ... Firmware Version: EMT02B6Q User Capacity: 250,059,350,016 bytes [250 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available Device is: In smartctl database 7.3/5319 ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4c SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed May 11 12:47:16 2022 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 133) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 9 Power_On_Hours -O--CK 097 097 000 - 11318 12 Power_Cycle_Count -O--CK 099 099 000 - 590 177 Wear_Leveling_Count PO--C- 095 095 000 - 100 179 Used_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 0 181 Program_Fail_Cnt_Total -O--CK 100 100 010 - 0 182 Erase_Fail_Count_Total -O--CK 100 100 010 - 0 183 Runtime_Bad_Block PO--C- 100 100 010 - 0 187 Uncorrectable_Error_Cnt -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O--CK 072 041 000 - 28 195 ECC_Error_Rate -O-RC- 200 200 000 - 0 199 CRC_Error_Count -OSRCK 100 100 000 - 0 235 POR_Recovery_Count -O--C- 099 099 000 - 21 241 Total_LBAs_Written -O--CK 099 099 000 - 19140732533 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa1 SL VS 16 Device vendor specific log 0xa5 SL VS 16 Device vendor specific log 0xce SL VS 16 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 255 0 65535 Read_scanning was never started Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 28 Celsius Power Cycle Min/Max Temperature: 22/28 Celsius Lifetime Min/Max Temperature: 16/59 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 10 minutes Min/Max recommended Temperature: 0/70 Celsius Min/Max Temperature Limit: 0/70 Celsius Temperature History Size (Index): 128 (56) Index Estimated Time Temperature Celsius 57 2022-05-10 15:30 23 **** ... ..( 2 skipped). .. **** 60 2022-05-10 16:00 23 **** 61 2022-05-10 16:10 24 ***** ... ..( 2 skipped). .. ***** 64 2022-05-10 16:40 24 ***** 65 2022-05-10 16:50 23 **** 66 2022-05-10 17:00 23 **** 67 2022-05-10 17:10 24 ***** 68 2022-05-10 17:20 24 ***** 69 2022-05-10 17:30 24 ***** 70 2022-05-10 17:40 23 **** 71 2022-05-10 17:50 24 ***** 72 2022-05-10 18:00 24 ***** 73 2022-05-10 18:10 24 ***** 74 2022-05-10 18:20 23 **** 75 2022-05-10 18:30 24 ***** ... ..( 10 skipped). .. ***** 86 2022-05-10 20:20 24 ***** 87 2022-05-10 20:30 ? - 88 2022-05-10 20:40 ? - 89 2022-05-10 20:50 21 ** 90 2022-05-10 21:00 23 **** 91 2022-05-10 21:10 23 **** 92 2022-05-10 21:20 23 **** 93 2022-05-10 21:30 24 ***** 94 2022-05-10 21:40 26 ******* 95 2022-05-10 21:50 26 ******* 96 2022-05-10 22:00 26 ******* 97 2022-05-10 22:10 28 ********* 98 2022-05-10 22:20 24 ***** 99 2022-05-10 22:30 23 **** ... ..( 7 skipped). .. **** 107 2022-05-10 23:50 23 **** 108 2022-05-11 00:00 24 ***** ... ..( 8 skipped). .. ***** 117 2022-05-11 01:30 24 ***** 118 2022-05-11 01:40 25 ****** 119 2022-05-11 01:50 28 ********* 120 2022-05-11 02:00 25 ****** ... ..( 9 skipped). .. ****** 2 2022-05-11 03:40 25 ****** 3 2022-05-11 03:50 26 ******* 4 2022-05-11 04:00 25 ****** 5 2022-05-11 04:10 25 ****** 6 2022-05-11 04:20 26 ******* ... ..( 19 skipped). .. ******* 26 2022-05-11 07:40 26 ******* 27 2022-05-11 07:50 25 ****** ... ..( 5 skipped). .. ****** 33 2022-05-11 08:50 25 ****** 34 2022-05-11 09:00 26 ******* 35 2022-05-11 09:10 26 ******* 36 2022-05-11 09:20 26 ******* 37 2022-05-11 09:30 27 ******** 38 2022-05-11 09:40 26 ******* 39 2022-05-11 09:50 25 ****** 40 2022-05-11 10:00 ? - 41 2022-05-11 10:10 22 *** 42 2022-05-11 10:20 23 **** 43 2022-05-11 10:30 24 ***** 44 2022-05-11 10:40 25 ****** 45 2022-05-11 10:50 25 ****** 46 2022-05-11 11:00 25 ****** 47 2022-05-11 11:10 26 ******* 48 2022-05-11 11:20 26 ******* 49 2022-05-11 11:30 27 ******** ... ..( 2 skipped). .. ******** 52 2022-05-11 12:00 27 ******** 53 2022-05-11 12:10 28 ********* 54 2022-05-11 12:20 28 ********* 55 2022-05-11 12:30 27 ******** 56 2022-05-11 12:40 28 ********* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC