/dev/ada0 smartctl 7.2 2021-09-14 r5236 [FreeBSD 13.0-STABLE amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Samsung based SSDs Device Model: SAMSUNG MZNLN256HCHP-000H1 Serial Number: -- LU WWN Device Id: 5 002538 ... Firmware Version: EMT22H0Q User Capacity: 256,060,514,304 bytes [256 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: < 1.8 inches TRIM Command: Available, deterministic Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4c SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon Feb 14 13:34:49 2022 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x02) Offline data collection activity was completed without error. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 2160) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 36) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 002 - 0 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 9 Power_On_Hours -O--CK 094 094 001 - 3526 11 Unknown_SSD_Attribute -O---K 099 099 001 - 274 12 Power_Cycle_Count -O--CK 098 098 001 - 1101 170 Unused_Rsvd_Blk_Ct_Chip PO--CK 100 100 010 - 776 171 Program_Fail_Count_Chip -O---K 100 100 010 - 0 172 Erase_Fail_Count_Chip -O--CK 100 100 010 - 0 173 Wear_Leveling_Count PO--CK 097 097 005 - 59 174 Unexpect_Power_Loss_Ct -O--CK 099 099 001 - 274 183 Runtime_Bad_Block -O--CK 099 099 001 - 1 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Uncorrectable_Error_Cnt -O--CK 100 100 000 - 0 188 Command_Timeout -O--CK 100 100 000 - 4 190 Airflow_Temperature_Cel -O---K 069 050 040 - 31 196 Reallocated_Event_Count -O--CK 253 253 001 - 0 198 Offline_Uncorrectable ----CK 100 100 001 - 0 199 CRC_Error_Count -O---K 100 100 001 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x04 GPL,SL R/O 3 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xb6 GPL,SL VS 127 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] Warning! SMART Selective Self-Test Log Structure error: invalid SMART checksum. SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 255 0 65535 Read_scanning was completed without error Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: SCT command executing in background (5) Current Temperature: 31 Celsius Power Cycle Min/Max Temperature: 28/40 Celsius Lifetime Min/Max Temperature: 0/70 Celsius Under/Over Temperature Limit Count: 4294967295/4294901760 SMART Status: 0xffff (Reserved) SCT Temperature History Version: 3 (Unknown, should be 2) Temperature Sampling Period: 1 minute Temperature Logging Interval: 10 minutes Min/Max recommended Temperature: 0/70 Celsius Min/Max Temperature Limit: 0/70 Celsius Temperature History Size (Index): 128 (120) Index Estimated Time Temperature Celsius 121 2022-02-13 16:20 ? - ... ..( 5 skipped). .. - 127 2022-02-13 17:20 ? - 0 2022-02-13 17:30 40 ********************* 1 2022-02-13 17:40 30 *********** 2 2022-02-13 17:50 31 ************ 3 2022-02-13 18:00 32 ************* 4 2022-02-13 18:10 33 ************** 5 2022-02-13 18:20 33 ************** 6 2022-02-13 18:30 34 *************** 7 2022-02-13 18:40 34 *************** 8 2022-02-13 18:50 34 *************** 9 2022-02-13 19:00 35 **************** 10 2022-02-13 19:10 34 *************** 11 2022-02-13 19:20 34 *************** 12 2022-02-13 19:30 34 *************** 13 2022-02-13 19:40 35 **************** 14 2022-02-13 19:50 35 **************** 15 2022-02-13 20:00 35 **************** 16 2022-02-13 20:10 33 ************** 17 2022-02-13 20:20 31 ************ 18 2022-02-13 20:30 30 *********** 19 2022-02-13 20:40 29 ********** 20 2022-02-13 20:50 30 *********** 21 2022-02-13 21:00 30 *********** 22 2022-02-13 21:10 29 ********** ... ..( 7 skipped). .. ********** 30 2022-02-13 22:30 29 ********** 31 2022-02-13 22:40 28 ********* 32 2022-02-13 22:50 28 ********* 33 2022-02-13 23:00 29 ********** 34 2022-02-13 23:10 28 ********* ... ..( 27 skipped). .. ********* 62 2022-02-14 03:50 28 ********* 63 2022-02-14 04:00 29 ********** 64 2022-02-14 04:10 28 ********* 65 2022-02-14 04:20 29 ********** 66 2022-02-14 04:30 28 ********* ... ..( 2 skipped). .. ********* 69 2022-02-14 05:00 28 ********* 70 2022-02-14 05:10 29 ********** ... ..( 29 skipped). .. ********** 100 2022-02-14 10:10 29 ********** 101 2022-02-14 10:20 30 *********** 102 2022-02-14 10:30 31 ************ ... ..( 17 skipped). .. ************ 120 2022-02-14 13:30 31 ************ SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP Log 0x04) Page Offset Size Value Flags Description 0x01 ===== = = === == General Statistics (rev 2) == 0x01 0x018 6 11257497829 --- Logical Sectors Written 0x01 0x028 6 16424354045 --- Logical Sectors Read 0x01 0x1f8 7 0 -D-+ Unknown 0x05 ===== = = === == Temperature Statistics (rev 1) == 0x05 0x008 1 31 --- Current Temperature 0x05 0x020 1 49 --- Highest Temperature 0x05 0x028 1 23 --- Lowest Temperature |||_ C monitored condition met ||__ D supports DSN |___ N normalized value Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 23 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 23 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC