/dev/sd0 smartctl 7.4 2023-08-01 r5530 [OpenBSD 7.5 amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Apacer AS340/350 SSDs Device Model: Apacer AS340 240GB Serial Number: -- LU WWN Device Id: 5 02b2a2 ... Add. Product Id: mavlsata Firmware Version: V4.25.0 User Capacity: 240,057,409,536 bytes [240 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device TRIM Command: Available Device is: In smartctl database 7.3/5528 ATA Version is: ACS-3 T13/2161-D revision 4 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Fri Aug 2 23:17:27 2024 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART Status not supported: Incomplete response, ATA output registers missing SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x02) Offline data collection activity was completed without error. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x75) SMART execute Offline immediate. No Auto Offline data collection support. Abort Offline collection upon new command. No Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0002) Does not save SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x00) Error logging NOT supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 90) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SMART Attributes Data Structure revision number: 5 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 5 Reallocated_Sector_Ct 0x0033 100 100 010 Pre-fail Always - 0 9 Power_On_Hours 0x0033 100 100 010 Pre-fail Always - 2624 12 Power_Cycle_Count 0x0033 100 100 010 Pre-fail Always - 2461 161 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 164 Average_Erase_Count 0x0033 100 100 010 Pre-fail Always - 143315 165 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 228 166 Later_Bad_Block_Count 0x0033 100 100 010 Pre-fail Always - 34 167 SSD_Protect_Mode 0x0033 100 100 010 Pre-fail Always - 141 169 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 176 Erase_Fail_Count_Chip 0x0033 100 100 010 Pre-fail Always - 0 177 Wear_Leveling_Count 0x0033 100 100 010 Pre-fail Always - 0 178 Used_Rsvd_Blk_Cnt_Chip 0x0033 100 100 010 Pre-fail Always - 0 192 Unexpect_Power_Loss_Ct 0x0033 100 100 010 Pre-fail Always - 2 194 Temperature_Celsius 0x0033 100 100 010 Pre-fail Always - 40 195 Hardware_ECC_Recovered 0x0033 100 100 010 Pre-fail Always - 0 199 UDMA_CRC_Error_Count 0x0033 100 100 010 Pre-fail Always - 0 241 Total_LBAs_Written 0x0033 100 100 010 Pre-fail Always - 10345 242 Total_LBAs_Read 0x0033 100 100 010 Pre-fail Always - 2476 243 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 244 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 245 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 246 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 248 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 249 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 250 Read_Error_Retry_Rate 0x0033 100 100 010 Pre-fail Always - 0 251 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 252 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 253 Unknown_Attribute 0x0033 100 100 010 Pre-fail Always - 0 254 Unknown_SSD_Attribute 0x0033 100 100 010 Pre-fail Always - 0 SMART Error Log not supported SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. The above only provides legacy SMART information - try 'smartctl -x' for more