/dev/ada0 smartctl 7.3 2022-02-28 r5338 [FreeBSD 13.1-RELEASE amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint F3 Device Model: SAMSUNG HD502HJ Serial Number: -- LU WWN Device Id: 5 0024e9 ... Firmware Version: 1AJ10006 User Capacity: 500,107,862,016 bytes [500 GB] Sector Size: 512 bytes logical/physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database 7.3/5319 ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Mon Jan 30 13:18:22 2023 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Disabled Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED See vendor-specific Attribute list for marginal Attributes. General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 4740) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 79) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 100 100 051 - 9 2 Throughput_Performance POS--K 252 252 000 - 0 3 Spin_Up_Time PO---K 081 081 025 - 5800 4 Start_Stop_Count -O--CK 097 097 000 - 3141 5 Reallocated_Sector_Ct PO--CK 252 252 010 - 0 7 Seek_Error_Rate POSR-K 252 252 051 - 0 8 Seek_Time_Performance P-S--K 252 252 015 - 0 9 Power_On_Hours -O--CK 100 100 000 - 27955 10 Spin_Retry_Count PO--CK 252 252 051 - 0 11 Calibration_Retry_Count -O--CK 252 252 000 - 0 12 Power_Cycle_Count -O--CK 097 097 000 - 3169 183 Runtime_Bad_Block -O--CK 252 252 010 - 0 184 End-to-End_Error PO--CK 252 252 097 - 0 186 Unknown_Attribute -O--CK 252 252 000 - 0 187 Reported_Uncorrect -O--CK 252 252 000 - 0 188 Command_Timeout -O--CK 252 252 000 - 0 190 Airflow_Temperature_Cel -O---- 069 039 040 Past 31 (Min/Max 7/61) 191 G-Sense_Error_Rate -O---K 100 100 000 - 10 192 Power-Off_Retract_Count -O---K 252 252 000 - 0 193 Load_Cycle_Count -O--CK 100 100 000 - 3178 194 Temperature_Celsius -O---- 064 039 000 - 31 (Min/Max 7/61) 195 Hardware_ECC_Recovered -O-RCK 100 100 000 - 0 196 Reallocated_Event_Count -O--CK 252 252 000 - 0 197 Current_Pending_Sector -O--CK 252 252 000 - 0 198 Offline_Uncorrectable ----CK 252 252 000 - 0 199 UDMA_CRC_Error_Count -OS-CK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-K 100 100 000 - 2729 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 2 Extended self-test log 0x08 GPL R/O 2 Power Conditions log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (2 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (2 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 23288 - # 2 Short offline Completed without error 00% 22683 - # 3 Short offline Completed without error 00% 22077 - # 4 Short offline Completed without error 00% 21810 - # 5 Short offline Completed without error 00% 21462 - # 6 Short offline Completed without error 00% 19188 - # 7 Short offline Completed without error 00% 19187 - # 8 Extended offline Aborted by host 90% 1 - SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Completed [00% left] (0-65535) 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 31 Celsius Power Cycle Min/Max Temperature: 17/31 Celsius Lifetime Min/Max Temperature: 13/62 Celsius Specified Max Operating Temperature: 80 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 5 minutes Temperature Logging Interval: 5 minutes Min/Max recommended Temperature: -5/80 Celsius Min/Max Temperature Limit: -10/85 Celsius Temperature History Size (Index): 128 (16) Index Estimated Time Temperature Celsius 17 2023-01-30 02:40 24 ***** ... ..( 36 skipped). .. ***** 54 2023-01-30 05:45 24 ***** 55 2023-01-30 05:50 25 ****** 56 2023-01-30 05:55 25 ****** 57 2023-01-30 06:00 24 ***** ... ..( 3 skipped). .. ***** 61 2023-01-30 06:20 24 ***** 62 2023-01-30 06:25 25 ****** ... ..( 2 skipped). .. ****** 65 2023-01-30 06:40 25 ****** 66 2023-01-30 06:45 24 ***** 67 2023-01-30 06:50 25 ****** ... ..( 12 skipped). .. ****** 80 2023-01-30 07:55 25 ****** 81 2023-01-30 08:00 26 ******* ... ..( 16 skipped). .. ******* 98 2023-01-30 09:25 26 ******* 99 2023-01-30 09:30 25 ****** 100 2023-01-30 09:35 25 ****** 101 2023-01-30 09:40 24 ***** 102 2023-01-30 09:45 24 ***** 103 2023-01-30 09:50 24 ***** 104 2023-01-30 09:55 17 - 105 2023-01-30 10:00 20 * 106 2023-01-30 10:05 21 ** 107 2023-01-30 10:10 22 *** 108 2023-01-30 10:15 23 **** 109 2023-01-30 10:20 23 **** 110 2023-01-30 10:25 24 ***** 111 2023-01-30 10:30 24 ***** 112 2023-01-30 10:35 25 ****** 113 2023-01-30 10:40 25 ****** 114 2023-01-30 10:45 25 ****** 115 2023-01-30 10:50 26 ******* 116 2023-01-30 10:55 17 - 117 2023-01-30 11:00 20 * 118 2023-01-30 11:05 23 **** 119 2023-01-30 11:10 25 ****** 120 2023-01-30 11:15 26 ******* 121 2023-01-30 11:20 26 ******* 122 2023-01-30 11:25 27 ******** 123 2023-01-30 11:30 27 ******** 124 2023-01-30 11:35 28 ********* ... ..( 10 skipped). .. ********* 7 2023-01-30 12:30 28 ********* 8 2023-01-30 12:35 29 ********** 9 2023-01-30 12:40 28 ********* ... ..( 2 skipped). .. ********* 12 2023-01-30 12:55 28 ********* 13 2023-01-30 13:00 30 *********** 14 2023-01-30 13:05 31 ************ 15 2023-01-30 13:10 31 ************ 16 2023-01-30 13:15 31 ************ SCT Error Recovery Control: Read: 75 (7.5 seconds) Write: 75 (7.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 4 0 Command failed due to ICRC error 0x0002 4 0 R_ERR response for data FIS 0x0003 4 0 R_ERR response for device-to-host data FIS 0x0004 4 0 R_ERR response for host-to-device data FIS 0x0005 4 0 R_ERR response for non-data FIS 0x0006 4 0 R_ERR response for device-to-host non-data FIS 0x0007 4 0 R_ERR response for host-to-device non-data FIS 0x0008 4 0 Device-to-host non-data FIS retries 0x0009 4 15 Transition from drive PhyRdy to drive PhyNRdy 0x000a 4 15 Device-to-host register FISes sent due to a COMRESET 0x000b 4 0 CRC errors within host-to-device FIS 0x000d 4 0 Non-CRC errors within host-to-device FIS 0x000f 4 0 R_ERR response for host-to-device data FIS, CRC 0x0010 4 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 4 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 4 0 R_ERR response for host-to-device non-data FIS, non-CRC 0x8e00 4 0 Vendor specific 0x8e01 4 0 Vendor specific 0x8e02 4 0 Vendor specific 0x8e03 4 0 Vendor specific 0x8e04 4 0 Vendor specific 0x8e05 4 0 Vendor specific 0x8e06 4 0 Vendor specific 0x8e07 4 0 Vendor specific 0x8e08 4 0 Vendor specific 0x8e09 4 0 Vendor specific 0x8e0a 4 0 Vendor specific 0x8e0b 4 0 Vendor specific 0x8e0c 4 0 Vendor specific 0x8e0d 4 0 Vendor specific 0x8e0e 4 0 Vendor specific 0x8e0f 4 0 Vendor specific 0x8e10 4 0 Vendor specific 0x8e11 4 0 Vendor specific