/dev/ada0 smartctl 7.2 2020-12-30 r5155 [FreeBSD 12.2-RELEASE-p3 amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z7K500 Device Model: HGST HTS725050A7E630 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GH2OA420 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Fri Feb 19 06:09:27 2021 EST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 94) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 224 224 033 - 1 4 Start_Stop_Count -O--C- 099 099 000 - 2041 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 078 078 000 - 9664 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 2038 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 101 193 Load_Cycle_Count -O--C- 067 067 000 - 333043 194 Temperature_Celsius -O---- 200 200 000 - 30 (Min/Max 10/50) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 30 Celsius Power Cycle Min/Max Temperature: 19/33 Celsius Lifetime Min/Max Temperature: 10/50 Celsius Specified Max Operating Temperature: 32 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (57) Index Estimated Time Temperature Celsius 58 2021-02-19 04:02 26 ******* 59 2021-02-19 04:03 26 ******* 60 2021-02-19 04:04 ? - 61 2021-02-19 04:05 21 ** 62 2021-02-19 04:06 22 *** 63 2021-02-19 04:07 23 **** 64 2021-02-19 04:08 23 **** 65 2021-02-19 04:09 24 ***** 66 2021-02-19 04:10 25 ****** 67 2021-02-19 04:11 25 ****** 68 2021-02-19 04:12 26 ******* ... ..( 4 skipped). .. ******* 73 2021-02-19 04:17 26 ******* 74 2021-02-19 04:18 27 ******** 75 2021-02-19 04:19 26 ******* 76 2021-02-19 04:20 27 ******** 77 2021-02-19 04:21 27 ******** 78 2021-02-19 04:22 28 ********* 79 2021-02-19 04:23 27 ******** 80 2021-02-19 04:24 28 ********* 81 2021-02-19 04:25 28 ********* 82 2021-02-19 04:26 27 ******** ... ..( 13 skipped). .. ******** 96 2021-02-19 04:40 27 ******** 97 2021-02-19 04:41 26 ******* 98 2021-02-19 04:42 27 ******** ... ..( 10 skipped). .. ******** 109 2021-02-19 04:53 27 ******** 110 2021-02-19 04:54 26 ******* 111 2021-02-19 04:55 27 ******** 112 2021-02-19 04:56 26 ******* 113 2021-02-19 04:57 27 ******** 114 2021-02-19 04:58 27 ******** 115 2021-02-19 04:59 26 ******* 116 2021-02-19 05:00 26 ******* 117 2021-02-19 05:01 27 ******** 118 2021-02-19 05:02 26 ******* 119 2021-02-19 05:03 ? - 120 2021-02-19 05:04 16 - 121 2021-02-19 05:05 18 - 122 2021-02-19 05:06 18 - 123 2021-02-19 05:07 19 - 124 2021-02-19 05:08 20 * 125 2021-02-19 05:09 20 * 126 2021-02-19 05:10 20 * 127 2021-02-19 05:11 21 ** 0 2021-02-19 05:12 21 ** 1 2021-02-19 05:13 21 ** 2 2021-02-19 05:14 22 *** ... ..( 4 skipped). .. *** 7 2021-02-19 05:19 22 *** 8 2021-02-19 05:20 23 **** ... ..( 3 skipped). .. **** 12 2021-02-19 05:24 23 **** 13 2021-02-19 05:25 ? - 14 2021-02-19 05:26 20 * 15 2021-02-19 05:27 21 ** 16 2021-02-19 05:28 22 *** 17 2021-02-19 05:29 23 **** 18 2021-02-19 05:30 23 **** 19 2021-02-19 05:31 24 ***** 20 2021-02-19 05:32 25 ****** 21 2021-02-19 05:33 25 ****** 22 2021-02-19 05:34 26 ******* 23 2021-02-19 05:35 27 ******** 24 2021-02-19 05:36 28 ********* 25 2021-02-19 05:37 28 ********* 26 2021-02-19 05:38 28 ********* 27 2021-02-19 05:39 29 ********** 28 2021-02-19 05:40 29 ********** 29 2021-02-19 05:41 30 *********** ... ..( 2 skipped). .. *********** 32 2021-02-19 05:44 30 *********** 33 2021-02-19 05:45 31 ************ ... ..( 6 skipped). .. ************ 40 2021-02-19 05:52 31 ************ 41 2021-02-19 05:53 32 ************* 42 2021-02-19 05:54 31 ************ 43 2021-02-19 05:55 32 ************* ... ..( 2 skipped). .. ************* 46 2021-02-19 05:58 32 ************* 47 2021-02-19 05:59 33 ************** ... ..( 5 skipped). .. ************** 53 2021-02-19 06:05 33 ************** 54 2021-02-19 06:06 32 ************* 55 2021-02-19 06:07 31 ************ 56 2021-02-19 06:08 31 ************ 57 2021-02-19 06:09 30 *********** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 6 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 6 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS