/dev/ada0 smartctl 7.2 2021-09-14 r5236 [FreeBSD 13.1-RC1 amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi Travelstar 5K160 Device Model: Hitachi HTS541612J9SA00 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: SBDOC70P User Capacity: 120,034,123,776 bytes [120 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA/ATAPI-7 T13/1532D revision 1 Local Time is: Fri Apr 8 21:50:33 2022 EDT SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM level is: 254 (maximum performance), recommended: 128 APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Unavailable === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 645) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 73) minutes. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 238 238 033 - 1 4 Start_Stop_Count -O--C- 094 094 000 - 9781 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 075 075 000 - 11095 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 097 097 000 - 5416 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 098 098 000 - 403 193 Load_Cycle_Count -O--C- 043 043 000 - 576845 194 Temperature_Celsius -O---- 161 161 000 - 34 (Min/Max 14/60) 196 Reallocated_Event_Count -O--CK 100 100 000 - 40 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 253 000 - 24026 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log SMART Extended Comprehensive Error Log Version: 1 (1 sectors) Device Error Count: 24247 (device log contains only the most recent 4 errors) CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 24247 [2] occurred at disk power-on lifetime: 11080 hours (461 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 00 01 00 00 00 00 00 01 a0 00 Error: ICRC, ABRT at LBA = 0x00000001 = 1 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 61 0a 00 00 01 00 00 00 00 00 01 a0 ff 02:19:47.600 WRITE FPDMA QUEUED 61 0a 00 09 80 00 00 08 9a 6f b8 48 ff 02:19:47.600 WRITE FPDMA QUEUED 61 0a 00 00 a0 00 00 08 9a 5f 28 40 08 02:19:47.000 WRITE FPDMA QUEUED 61 06 10 00 98 00 00 08 9a 69 28 40 08 02:19:47.000 WRITE FPDMA QUEUED 61 0a 00 00 90 00 00 08 9a 6f 38 40 08 02:19:47.000 WRITE FPDMA QUEUED Error 24246 [1] occurred at disk power-on lifetime: 11080 hours (461 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 00 a0 00 00 08 9a 68 89 48 00 Error: ICRC, ABRT at LBA = 0x089a6889 = 144337033 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 61 06 08 00 a0 00 00 08 98 12 00 40 08 02:19:46.200 WRITE FPDMA QUEUED 61 0a 00 00 78 00 00 08 98 08 00 40 08 02:19:46.200 WRITE FPDMA QUEUED 61 08 c8 00 70 00 00 08 9a 7f 38 40 08 02:19:46.200 WRITE FPDMA QUEUED 61 06 00 00 68 00 00 08 9a 79 38 40 08 02:19:46.200 WRITE FPDMA QUEUED 61 0a 00 00 60 00 00 08 9a 6f 38 40 08 02:19:46.200 WRITE FPDMA QUEUED Error 24245 [0] occurred at disk power-on lifetime: 11080 hours (461 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 00 01 00 00 00 00 00 01 a0 00 Error: ICRC, ABRT at LBA = 0x00000001 = 1 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 61 05 40 00 01 00 00 00 00 00 01 a0 ff 02:19:44.500 WRITE FPDMA QUEUED 61 05 40 01 e0 00 00 08 9c 66 20 48 ff 02:19:44.500 WRITE FPDMA QUEUED 61 05 40 00 88 00 00 08 9c 70 08 40 08 02:19:44.500 WRITE FPDMA QUEUED 61 02 c8 00 80 00 00 08 9c 6d 40 40 08 02:19:44.500 WRITE FPDMA QUEUED 61 05 40 00 78 00 00 08 9c 68 00 40 08 02:19:44.500 WRITE FPDMA QUEUED Error 24244 [3] occurred at disk power-on lifetime: 11080 hours (461 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 04 b0 00 00 08 9c 70 99 48 00 Error: ICRC, ABRT at LBA = 0x089c7099 = 144470169 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 61 02 a0 00 a0 00 00 08 9c 85 60 40 08 02:19:43.500 WRITE FPDMA QUEUED 61 05 40 00 98 00 00 08 9c 60 00 40 08 02:19:43.500 WRITE FPDMA QUEUED 61 02 c0 00 90 00 00 08 9c 65 40 40 08 02:19:43.500 WRITE FPDMA QUEUED 61 05 40 00 88 00 00 08 9c 68 00 40 08 02:19:43.500 WRITE FPDMA QUEUED 61 02 c8 00 80 00 00 08 9c 6d 40 40 08 02:19:43.500 WRITE FPDMA QUEUED SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Commands not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0009 2 4 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS