/dev/ada0 smartctl 7.4 2023-08-01 r5530 [FreeBSD 14.1-RELEASE-p3 amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z5K500 Device Model: APPLE HDD HTS545050A7E362 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GG2AB990 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5528 ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Mon Sep 2 14:54:14 2024 IST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 108) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 214 214 033 - 1 4 Start_Stop_Count -O--C- 100 100 000 - 963 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 084 084 000 - 7212 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 963 160 Unknown_Attribute -O--CK 100 100 000 - 0 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 12884901999 193 Load_Cycle_Count -O--C- 076 076 000 - 245894 194 Temperature_Celsius -O---- 176 176 000 - 34 (Min/Max 10/47) 195 Hardware_ECC_Recovered -O-R-- 100 100 000 - 0 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 254 Free_Fall_Sensor -O--CK 100 100 000 - 26 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 34 Celsius Power Cycle Min/Max Temperature: 24/41 Celsius Lifetime Min/Max Temperature: 10/47 Celsius Specified Max Operating Temperature: 28 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (121) Index Estimated Time Temperature Celsius 122 2024-09-02 12:47 36 ***************** 123 2024-09-02 12:48 37 ****************** ... ..( 3 skipped). .. ****************** 127 2024-09-02 12:52 37 ****************** 0 2024-09-02 12:53 36 ***************** ... ..( 3 skipped). .. ***************** 4 2024-09-02 12:57 36 ***************** 5 2024-09-02 12:58 35 **************** ... ..( 4 skipped). .. **************** 10 2024-09-02 13:03 35 **************** 11 2024-09-02 13:04 36 ***************** 12 2024-09-02 13:05 35 **************** ... ..( 12 skipped). .. **************** 25 2024-09-02 13:18 35 **************** 26 2024-09-02 13:19 34 *************** 27 2024-09-02 13:20 35 **************** 28 2024-09-02 13:21 35 **************** 29 2024-09-02 13:22 35 **************** 30 2024-09-02 13:23 34 *************** 31 2024-09-02 13:24 34 *************** 32 2024-09-02 13:25 34 *************** 33 2024-09-02 13:26 35 **************** 34 2024-09-02 13:27 34 *************** 35 2024-09-02 13:28 35 **************** 36 2024-09-02 13:29 34 *************** ... ..( 12 skipped). .. *************** 49 2024-09-02 13:42 34 *************** 50 2024-09-02 13:43 35 **************** ... ..( 2 skipped). .. **************** 53 2024-09-02 13:46 35 **************** 54 2024-09-02 13:47 34 *************** ... ..( 13 skipped). .. *************** 68 2024-09-02 14:01 34 *************** 69 2024-09-02 14:02 35 **************** ... ..( 2 skipped). .. **************** 72 2024-09-02 14:05 35 **************** 73 2024-09-02 14:06 34 *************** 74 2024-09-02 14:07 35 **************** 75 2024-09-02 14:08 34 *************** ... ..( 2 skipped). .. *************** 78 2024-09-02 14:11 34 *************** 79 2024-09-02 14:12 35 **************** 80 2024-09-02 14:13 35 **************** 81 2024-09-02 14:14 35 **************** 82 2024-09-02 14:15 34 *************** ... ..( 9 skipped). .. *************** 92 2024-09-02 14:25 34 *************** 93 2024-09-02 14:26 35 **************** ... ..( 2 skipped). .. **************** 96 2024-09-02 14:29 35 **************** 97 2024-09-02 14:30 36 ***************** ... ..( 2 skipped). .. ***************** 100 2024-09-02 14:33 36 ***************** 101 2024-09-02 14:34 37 ****************** ... ..( 8 skipped). .. ****************** 110 2024-09-02 14:43 37 ****************** 111 2024-09-02 14:44 36 ***************** 112 2024-09-02 14:45 36 ***************** 113 2024-09-02 14:46 35 **************** ... ..( 2 skipped). .. **************** 116 2024-09-02 14:49 35 **************** 117 2024-09-02 14:50 34 *************** ... ..( 3 skipped). .. *************** 121 2024-09-02 14:54 34 *************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 24 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 18 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS