/dev/ada0 smartctl 7.5 2025-04-30 r5714 [FreeBSD 15.0-PRERELEASE amd64] (local build) Copyright (C) 2002-25, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: SanDisk SD6SB1M-128G-1006 Serial Number: -- LU WWN Device Id: 5 001b44 ... Firmware Version: X231706 User Capacity: 128,035,676,160 bytes [128 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: Unknown (0x000a) TRIM Command: Available, deterministic, zeroed Device is: Not in smartctl database 7.5/5706 ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Thu Sep 11 13:34:50 2025 AWST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 10) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 100 100 002 - 0 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 9 Power_On_Hours -O--CK 041 041 --- - 25844 12 Power_Cycle_Count -O--CK 100 100 --- - 2352 170 Unknown_Attribute PO--CK 100 100 010 - 0 171 Unknown_Attribute -O--CK 100 100 --- - 0 172 Unknown_Attribute -O--CK 100 100 --- - 0 173 Unknown_Attribute PO--CK 090 090 005 - 1404483600385 174 Unknown_Attribute -O--CK 100 100 --- - 272 183 Runtime_Bad_Block -O--CK 253 253 --- - 0 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 --- - 0 188 Command_Timeout -O--CK 100 098 --- - 4 190 Airflow_Temperature_Cel -O---K 063 048 014 - 37 196 Reallocated_Event_Count -O--CK 100 100 --- - 0 199 UDMA_CRC_Error_Count -O--CK 100 100 --- - 0 243 Unknown_Attribute -O--CK 100 100 --- - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x04 GPL,SL R/O 8 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 3 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 257 (0x0101) Device State: Active (0) Current Temperature: 37 Celsius Power Cycle Min/Max Temperature: 27/40 Celsius Lifetime Min/Max Temperature: 27/40 Celsius Specified Max Operating Temperature: 37 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 01 00 01 00 01 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: -10/70 Celsius Min/Max Temperature Limit: -15/90 Celsius Temperature History Size (Index): 256 (106) Index Estimated Time Temperature Celsius 107 2025-09-11 09:19 31 ************ ... ..(159 skipped). .. ************ 11 2025-09-11 11:59 31 ************ 12 2025-09-11 12:00 29 ********** 13 2025-09-11 12:01 29 ********** 14 2025-09-11 12:02 30 *********** 15 2025-09-11 12:03 30 *********** 16 2025-09-11 12:04 32 ************* ... ..( 2 skipped). .. ************* 19 2025-09-11 12:07 32 ************* 20 2025-09-11 12:08 33 ************** 21 2025-09-11 12:09 34 *************** ... ..( 2 skipped). .. *************** 24 2025-09-11 12:12 34 *************** 25 2025-09-11 12:13 35 **************** ... ..( 2 skipped). .. **************** 28 2025-09-11 12:16 35 **************** 29 2025-09-11 12:17 34 *************** 30 2025-09-11 12:18 35 **************** ... ..( 10 skipped). .. **************** 41 2025-09-11 12:29 35 **************** 42 2025-09-11 12:30 36 ***************** 43 2025-09-11 12:31 36 ***************** 44 2025-09-11 12:32 37 ****************** ... ..( 4 skipped). .. ****************** 49 2025-09-11 12:37 37 ****************** 50 2025-09-11 12:38 38 ******************* 51 2025-09-11 12:39 32 ************* 52 2025-09-11 12:40 33 ************** 53 2025-09-11 12:41 34 *************** 54 2025-09-11 12:42 34 *************** 55 2025-09-11 12:43 35 **************** ... ..( 10 skipped). .. **************** 66 2025-09-11 12:54 35 **************** 67 2025-09-11 12:55 34 *************** 68 2025-09-11 12:56 32 ************* 69 2025-09-11 12:57 34 *************** 70 2025-09-11 12:58 35 **************** ... ..( 2 skipped). .. **************** 73 2025-09-11 13:01 35 **************** 74 2025-09-11 13:02 33 ************** 75 2025-09-11 13:03 33 ************** 76 2025-09-11 13:04 34 *************** 77 2025-09-11 13:05 35 **************** 78 2025-09-11 13:06 35 **************** 79 2025-09-11 13:07 36 ***************** ... ..( 14 skipped). .. ***************** 94 2025-09-11 13:22 36 ***************** 95 2025-09-11 13:23 35 **************** 96 2025-09-11 13:24 36 ***************** 97 2025-09-11 13:25 36 ***************** 98 2025-09-11 13:26 36 ***************** 99 2025-09-11 13:27 34 *************** ... ..( 2 skipped). .. *************** 102 2025-09-11 13:30 34 *************** 103 2025-09-11 13:31 36 ***************** 104 2025-09-11 13:32 36 ***************** 105 2025-09-11 13:33 37 ****************** 106 2025-09-11 13:34 37 ****************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP Log 0x04) Page Offset Size Value Flags Description 0x07 ===== = = === == Solid State Device Statistics (rev 1) == 0x07 0x008 1 10 --- Percentage Used Endurance Indicator |||_ C monitored condition met ||__ D supports DSN |___ N normalized value Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 4 0 Command failed due to ICRC error 0x0002 4 0 R_ERR response for data FIS 0x0005 4 0 R_ERR response for non-data FIS 0x000a 4 3 Device-to-host register FISes sent due to a COMRESET