Probe #6412e6fb23 of Apple MacBook7,1

Log: smartctl

/dev/ada0 smartctl 7.3 2022-02-28 r5338 [FreeBSD 13.2-RELEASE amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar 5K750 Device Model: APPLE HDD HTS547550A9E384 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JE3AD70F User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5319 ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Fri Jun 16 17:20:07 2023 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 129) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 253 253 033 - 1 4 Start_Stop_Count -O--C- 095 095 000 - 9417 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 076 076 000 - 10573 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 095 095 000 - 8922 160 Unknown_Attribute -O--CK 100 100 000 - 0 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 097 097 000 - 2791728873577 193 Load_Cycle_Count -O--C- 020 020 000 - 801869 194 Temperature_Celsius -O---- 206 206 000 - 29 (Min/Max 8/47) 195 Hardware_ECC_Recovered -O-R-- 080 080 000 - 5767200 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 254 Free_Fall_Sensor -O--CK 037 037 000 - 4294983565 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 10552 - # 2 Extended offline Completed without error 00% 10544 - # 3 Extended offline Interrupted (host reset) 90% 10530 - # 4 Short offline Aborted by host 90% 10527 - # 5 Extended offline Interrupted (host reset) 30% 10524 - # 6 Extended offline Interrupted (host reset) 90% 10515 - # 7 Short offline Completed without error 00% 10510 - # 8 Short offline Completed without error 00% 10509 - # 9 Short offline Completed without error 00% 10488 - #10 Short offline Completed without error 00% 10464 - #11 Short offline Completed without error 00% 10458 - #12 Short offline Completed without error 00% 10453 - #13 Extended offline Interrupted (host reset) 70% 10453 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 29 Celsius Power Cycle Min/Max Temperature: 26/29 Celsius Lifetime Min/Max Temperature: 8/47 Celsius Specified Max Operating Temperature: 31 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (8) Index Estimated Time Temperature Celsius 9 2023-06-16 15:13 32 ************* ... ..( 16 skipped). .. ************* 26 2023-06-16 15:30 32 ************* 27 2023-06-16 15:31 31 ************ 28 2023-06-16 15:32 32 ************* 29 2023-06-16 15:33 32 ************* 30 2023-06-16 15:34 31 ************ 31 2023-06-16 15:35 31 ************ 32 2023-06-16 15:36 32 ************* ... ..( 2 skipped). .. ************* 35 2023-06-16 15:39 32 ************* 36 2023-06-16 15:40 31 ************ 37 2023-06-16 15:41 32 ************* 38 2023-06-16 15:42 31 ************ ... ..( 3 skipped). .. ************ 42 2023-06-16 15:46 31 ************ 43 2023-06-16 15:47 32 ************* 44 2023-06-16 15:48 31 ************ ... ..( 12 skipped). .. ************ 57 2023-06-16 16:01 31 ************ 58 2023-06-16 16:02 32 ************* 59 2023-06-16 16:03 31 ************ ... ..( 61 skipped). .. ************ 121 2023-06-16 17:05 31 ************ 122 2023-06-16 17:06 32 ************* 123 2023-06-16 17:07 31 ************ 124 2023-06-16 17:08 31 ************ 125 2023-06-16 17:09 32 ************* 126 2023-06-16 17:10 31 ************ 127 2023-06-16 17:11 32 ************* 0 2023-06-16 17:12 32 ************* 1 2023-06-16 17:13 ? - 2 2023-06-16 17:14 19 - 3 2023-06-16 17:15 ? - 4 2023-06-16 17:16 ? - 5 2023-06-16 17:17 27 ******** 6 2023-06-16 17:18 28 ********* 7 2023-06-16 17:19 28 ********* 8 2023-06-16 17:20 29 ********** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 3 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 3 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS


Hardware for Linux and BSD

GitHub