/dev/sd0 smartctl 7.3 2022-02-28 r5338 [OpenBSD 7.3 amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: KingFast Serial Number: -- Firmware Version: T0910A0 User Capacity: 256,060,514,304 bytes [256 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available, deterministic, zeroed Device is: Not in smartctl database 7.3/5319 ATA Version is: ACS-2 T13/2015-D revision 3 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon Jul 24 10:40:33 2023 CDT SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART Status not supported: Incomplete response, ATA output registers missing SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x11) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. No Selective Self-test supported. SMART capabilities: (0x0002) Does not save SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 10) minutes. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x0032 100 100 050 Old_age Always - 0 5 Reallocated_Sector_Ct 0x0032 100 100 050 Old_age Always - 0 9 Power_On_Hours 0x0032 100 100 050 Old_age Always - 99 12 Power_Cycle_Count 0x0032 100 100 050 Old_age Always - 120 160 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 0 161 Unknown_Attribute 0x0033 100 100 050 Pre-fail Always - 100 163 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 3 164 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 11841 165 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 25 166 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 4 167 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 9 168 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 5050 169 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 100 175 Program_Fail_Count_Chip 0x0032 100 100 050 Old_age Always - 0 176 Erase_Fail_Count_Chip 0x0032 100 100 050 Old_age Always - 0 177 Wear_Leveling_Count 0x0032 100 100 050 Old_age Always - 0 178 Used_Rsvd_Blk_Cnt_Chip 0x0032 100 100 050 Old_age Always - 0 181 Program_Fail_Cnt_Total 0x0032 100 100 050 Old_age Always - 0 182 Erase_Fail_Count_Total 0x0032 100 100 050 Old_age Always - 0 192 Power-Off_Retract_Count 0x0032 100 100 050 Old_age Always - 12 194 Temperature_Celsius 0x0022 100 100 050 Old_age Always - 40 195 Hardware_ECC_Recovered 0x0032 100 100 050 Old_age Always - 0 196 Reallocated_Event_Count 0x0032 100 100 050 Old_age Always - 0 197 Current_Pending_Sector 0x0032 100 100 050 Old_age Always - 0 198 Offline_Uncorrectable 0x0032 100 100 050 Old_age Always - 0 199 UDMA_CRC_Error_Count 0x0032 100 100 050 Old_age Always - 0 232 Available_Reservd_Space 0x0032 100 100 050 Old_age Always - 100 241 Total_LBAs_Written 0x0030 100 100 050 Old_age Offline - 16760 242 Total_LBAs_Read 0x0030 100 100 050 Old_age Offline - 7670 245 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 10165 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] Selective Self-tests/Logging not supported