/dev/ada0 smartctl 7.2 2020-12-30 r5155 [FreeBSD 12.2-RELEASE-p3 amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z7K500 Device Model: HGST HTS725050A7E630 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GH2OA420 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Wed Feb 17 04:55:31 2021 EST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 94) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 218 218 033 - 1 4 Start_Stop_Count -O--C- 099 099 000 - 2037 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 078 078 000 - 9656 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 2034 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 101 193 Load_Cycle_Count -O--C- 067 067 000 - 331442 194 Temperature_Celsius -O---- 230 230 000 - 26 (Min/Max 10/50) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 26 Celsius Power Cycle Min/Max Temperature: 16/27 Celsius Lifetime Min/Max Temperature: 10/50 Celsius Specified Max Operating Temperature: 32 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (93) Index Estimated Time Temperature Celsius 94 2021-02-17 02:48 29 ********** ... ..( 3 skipped). .. ********** 98 2021-02-17 02:52 29 ********** 99 2021-02-17 02:53 30 *********** ... ..( 2 skipped). .. *********** 102 2021-02-17 02:56 30 *********** 103 2021-02-17 02:57 31 ************ 104 2021-02-17 02:58 31 ************ 105 2021-02-17 02:59 31 ************ 106 2021-02-17 03:00 30 *********** ... ..( 4 skipped). .. *********** 111 2021-02-17 03:05 30 *********** 112 2021-02-17 03:06 29 ********** ... ..( 3 skipped). .. ********** 116 2021-02-17 03:10 29 ********** 117 2021-02-17 03:11 30 *********** 118 2021-02-17 03:12 30 *********** 119 2021-02-17 03:13 29 ********** 120 2021-02-17 03:14 29 ********** 121 2021-02-17 03:15 28 ********* ... ..( 7 skipped). .. ********* 1 2021-02-17 03:23 28 ********* 2 2021-02-17 03:24 29 ********** 3 2021-02-17 03:25 29 ********** 4 2021-02-17 03:26 30 *********** 5 2021-02-17 03:27 30 *********** 6 2021-02-17 03:28 31 ************ ... ..( 5 skipped). .. ************ 12 2021-02-17 03:34 31 ************ 13 2021-02-17 03:35 32 ************* 14 2021-02-17 03:36 32 ************* 15 2021-02-17 03:37 32 ************* 16 2021-02-17 03:38 ? - 17 2021-02-17 03:39 18 - 18 2021-02-17 03:40 20 * 19 2021-02-17 03:41 21 ** 20 2021-02-17 03:42 22 *** ... ..( 2 skipped). .. *** 23 2021-02-17 03:45 22 *** 24 2021-02-17 03:46 23 **** ... ..( 7 skipped). .. **** 32 2021-02-17 03:54 23 **** 33 2021-02-17 03:55 24 ***** ... ..( 14 skipped). .. ***** 48 2021-02-17 04:10 24 ***** 49 2021-02-17 04:11 25 ****** 50 2021-02-17 04:12 24 ***** 51 2021-02-17 04:13 24 ***** 52 2021-02-17 04:14 25 ****** 53 2021-02-17 04:15 24 ***** 54 2021-02-17 04:16 25 ****** 55 2021-02-17 04:17 24 ***** 56 2021-02-17 04:18 25 ****** 57 2021-02-17 04:19 25 ****** 58 2021-02-17 04:20 24 ***** 59 2021-02-17 04:21 24 ***** 60 2021-02-17 04:22 25 ****** ... ..( 7 skipped). .. ****** 68 2021-02-17 04:30 25 ****** 69 2021-02-17 04:31 26 ******* 70 2021-02-17 04:32 26 ******* 71 2021-02-17 04:33 27 ******** ... ..( 3 skipped). .. ******** 75 2021-02-17 04:37 27 ******** 76 2021-02-17 04:38 26 ******* ... ..( 8 skipped). .. ******* 85 2021-02-17 04:47 26 ******* 86 2021-02-17 04:48 25 ****** 87 2021-02-17 04:49 25 ****** 88 2021-02-17 04:50 26 ******* ... ..( 4 skipped). .. ******* 93 2021-02-17 04:55 26 ******* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 10 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 10 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS