/dev/ada0 smartctl 7.4 2023-08-01 r5530 [FreeBSD 15.0-CURRENT amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Samsung based SSDs Device Model: Samsung SSD 850 EVO 250GB Serial Number: -- LU WWN Device Id: 5 002538 ... Firmware Version: EMT02B6Q User Capacity: 250,059,350,016 bytes [250 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available Device is: In smartctl database 7.3/5528 ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4c SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Fri Jan 12 10:18:41 2024 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 133) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 9 Power_On_Hours -O--CK 095 095 000 - 21481 12 Power_Cycle_Count -O--CK 094 094 000 - 5538 177 Wear_Leveling_Count PO--C- 087 087 000 - 267 179 Used_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 0 181 Program_Fail_Cnt_Total -O--CK 100 100 010 - 0 182 Erase_Fail_Count_Total -O--CK 100 100 010 - 0 183 Runtime_Bad_Block PO--C- 100 100 010 - 0 187 Uncorrectable_Error_Cnt -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O--CK 066 053 000 - 34 195 ECC_Error_Rate -O-RC- 200 200 000 - 0 199 CRC_Error_Count -OSRCK 100 100 000 - 0 235 POR_Recovery_Count -O--C- 099 099 000 - 1415 241 Total_LBAs_Written -O--CK 099 099 000 - 55335806394 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa1 SL VS 16 Device vendor specific log 0xa5 SL VS 16 Device vendor specific log 0xce SL VS 16 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 255 0 65535 Read_scanning was never started Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: ? Celsius Power Cycle Min/Max Temperature: 34/34 Celsius Lifetime Min/Max Temperature: 18/47 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 10 minutes Min/Max recommended Temperature: 0/70 Celsius Min/Max Temperature Limit: 0/70 Celsius Temperature History Size (Index): 128 (122) Index Estimated Time Temperature Celsius 123 2024-01-11 13:00 35 **************** 124 2024-01-11 13:10 34 *************** 125 2024-01-11 13:20 35 **************** 126 2024-01-11 13:30 34 *************** 127 2024-01-11 13:40 34 *************** 0 2024-01-11 13:50 ? - 1 2024-01-11 14:00 31 ************ 2 2024-01-11 14:10 32 ************* 3 2024-01-11 14:20 33 ************** 4 2024-01-11 14:30 34 *************** ... ..( 16 skipped). .. *************** 21 2024-01-11 17:20 34 *************** 22 2024-01-11 17:30 35 **************** 23 2024-01-11 17:40 35 **************** 24 2024-01-11 17:50 34 *************** 25 2024-01-11 18:00 35 **************** 26 2024-01-11 18:10 35 **************** 27 2024-01-11 18:20 34 *************** 28 2024-01-11 18:30 34 *************** 29 2024-01-11 18:40 35 **************** ... ..( 6 skipped). .. **************** 36 2024-01-11 19:50 35 **************** 37 2024-01-11 20:00 34 *************** 38 2024-01-11 20:10 35 **************** ... ..( 4 skipped). .. **************** 43 2024-01-11 21:00 35 **************** 44 2024-01-11 21:10 34 *************** 45 2024-01-11 21:20 35 **************** 46 2024-01-11 21:30 35 **************** 47 2024-01-11 21:40 34 *************** 48 2024-01-11 21:50 33 ************** 49 2024-01-11 22:00 33 ************** 50 2024-01-11 22:10 34 *************** ... ..( 4 skipped). .. *************** 55 2024-01-11 23:00 34 *************** 56 2024-01-11 23:10 35 **************** ... ..( 20 skipped). .. **************** 77 2024-01-12 02:40 35 **************** 78 2024-01-12 02:50 ? - 79 2024-01-12 03:00 30 *********** 80 2024-01-12 03:10 32 ************* 81 2024-01-12 03:20 33 ************** 82 2024-01-12 03:30 33 ************** 83 2024-01-12 03:40 34 *************** 84 2024-01-12 03:50 33 ************** 85 2024-01-12 04:00 33 ************** 86 2024-01-12 04:10 34 *************** 87 2024-01-12 04:20 33 ************** 88 2024-01-12 04:30 34 *************** 89 2024-01-12 04:40 34 *************** 90 2024-01-12 04:50 33 ************** 91 2024-01-12 05:00 33 ************** 92 2024-01-12 05:10 34 *************** 93 2024-01-12 05:20 33 ************** 94 2024-01-12 05:30 33 ************** 95 2024-01-12 05:40 34 *************** 96 2024-01-12 05:50 34 *************** 97 2024-01-12 06:00 34 *************** 98 2024-01-12 06:10 33 ************** 99 2024-01-12 06:20 33 ************** 100 2024-01-12 06:30 34 *************** ... ..( 7 skipped). .. *************** 108 2024-01-12 07:50 34 *************** 109 2024-01-12 08:00 33 ************** 110 2024-01-12 08:10 34 *************** ... ..( 10 skipped). .. *************** 121 2024-01-12 10:00 34 *************** 122 2024-01-12 10:10 ? - SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 5 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 5 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC /dev/nda0 smartctl 7.4 2023-08-01 r5530 [FreeBSD 15.0-CURRENT amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org Smartctl open device: /dev/nda0 failed: INQUIRY failed