/dev/ada0 smartctl 7.1 2019-12-30 r5022 [FreeBSD 12.1-RELEASE amd64] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Samsung based SSDs Device Model: Samsung SSD 850 EVO 500GB Serial Number: -- LU WWN Device Id: 5 002538 ... Firmware Version: EMT02B6Q User Capacity: 500,107,862,016 bytes [500 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4c SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon May 25 14:54:50 2020 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 265) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 9 Power_On_Hours -O--CK 097 097 000 - 12619 12 Power_Cycle_Count -O--CK 099 099 000 - 394 177 Wear_Leveling_Count PO--C- 092 092 000 - 158 179 Used_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 0 181 Program_Fail_Cnt_Total -O--CK 100 100 010 - 0 182 Erase_Fail_Count_Total -O--CK 100 100 010 - 0 183 Runtime_Bad_Block PO--C- 100 100 010 - 0 187 Uncorrectable_Error_Cnt -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O--CK 068 059 000 - 32 195 ECC_Error_Rate -O-RC- 200 200 000 - 0 199 CRC_Error_Count -OSRCK 098 098 000 - 1935 235 POR_Recovery_Count -O--C- 099 099 000 - 81 241 Total_LBAs_Written -O--CK 099 099 000 - 204406182262 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa1 SL VS 16 Device vendor specific log 0xa5 SL VS 16 Device vendor specific log 0xce SL VS 16 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 255 0 65535 Read_scanning was never started Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 32 Celsius Power Cycle Min/Max Temperature: 31/32 Celsius Lifetime Min/Max Temperature: 11/41 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 10 minutes Min/Max recommended Temperature: 0/70 Celsius Min/Max Temperature Limit: 0/70 Celsius Temperature History Size (Index): 128 (109) Index Estimated Time Temperature Celsius 110 2020-05-24 17:40 24 ***** 111 2020-05-24 17:50 25 ****** 112 2020-05-24 18:00 26 ******* 113 2020-05-24 18:10 25 ****** 114 2020-05-24 18:20 25 ****** 115 2020-05-24 18:30 25 ****** 116 2020-05-24 18:40 24 ***** 117 2020-05-24 18:50 28 ********* 118 2020-05-24 19:00 25 ****** 119 2020-05-24 19:10 26 ******* 120 2020-05-24 19:20 27 ******** 121 2020-05-24 19:30 26 ******* 122 2020-05-24 19:40 26 ******* 123 2020-05-24 19:50 26 ******* 124 2020-05-24 20:00 25 ****** ... ..( 2 skipped). .. ****** 127 2020-05-24 20:30 25 ****** 0 2020-05-24 20:40 24 ***** 1 2020-05-24 20:50 25 ****** 2 2020-05-24 21:00 25 ****** 3 2020-05-24 21:10 25 ****** 4 2020-05-24 21:20 26 ******* 5 2020-05-24 21:30 26 ******* 6 2020-05-24 21:40 26 ******* 7 2020-05-24 21:50 25 ****** 8 2020-05-24 22:00 24 ***** 9 2020-05-24 22:10 25 ****** 10 2020-05-24 22:20 25 ****** 11 2020-05-24 22:30 25 ****** 12 2020-05-24 22:40 26 ******* 13 2020-05-24 22:50 26 ******* 14 2020-05-24 23:00 25 ****** 15 2020-05-24 23:10 25 ****** 16 2020-05-24 23:20 27 ******** 17 2020-05-24 23:30 26 ******* 18 2020-05-24 23:40 25 ****** ... ..( 3 skipped). .. ****** 22 2020-05-25 00:20 25 ****** 23 2020-05-25 00:30 27 ******** 24 2020-05-25 00:40 26 ******* 25 2020-05-25 00:50 27 ******** 26 2020-05-25 01:00 26 ******* 27 2020-05-25 01:10 26 ******* 28 2020-05-25 01:20 25 ****** 29 2020-05-25 01:30 25 ****** 30 2020-05-25 01:40 26 ******* 31 2020-05-25 01:50 27 ******** 32 2020-05-25 02:00 25 ****** ... ..( 4 skipped). .. ****** 37 2020-05-25 02:50 25 ****** 38 2020-05-25 03:00 26 ******* 39 2020-05-25 03:10 25 ****** 40 2020-05-25 03:20 27 ******** 41 2020-05-25 03:30 25 ****** 42 2020-05-25 03:40 24 ***** 43 2020-05-25 03:50 25 ****** 44 2020-05-25 04:00 24 ***** 45 2020-05-25 04:10 27 ******** 46 2020-05-25 04:20 24 ***** 47 2020-05-25 04:30 25 ****** 48 2020-05-25 04:40 25 ****** 49 2020-05-25 04:50 25 ****** 50 2020-05-25 05:00 24 ***** 51 2020-05-25 05:10 24 ***** 52 2020-05-25 05:20 24 ***** 53 2020-05-25 05:30 25 ****** 54 2020-05-25 05:40 24 ***** 55 2020-05-25 05:50 25 ****** 56 2020-05-25 06:00 24 ***** 57 2020-05-25 06:10 25 ****** 58 2020-05-25 06:20 24 ***** 59 2020-05-25 06:30 25 ****** 60 2020-05-25 06:40 25 ****** 61 2020-05-25 06:50 25 ****** 62 2020-05-25 07:00 24 ***** 63 2020-05-25 07:10 25 ****** 64 2020-05-25 07:20 24 ***** 65 2020-05-25 07:30 28 ********* 66 2020-05-25 07:40 30 *********** 67 2020-05-25 07:50 30 *********** 68 2020-05-25 08:00 31 ************ 69 2020-05-25 08:10 31 ************ 70 2020-05-25 08:20 ? - 71 2020-05-25 08:30 31 ************ ... ..( 27 skipped). .. ************ 99 2020-05-25 13:10 31 ************ 100 2020-05-25 13:20 32 ************* ... ..( 8 skipped). .. ************* 109 2020-05-25 14:50 32 ************* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 3 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 3 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC