/dev/ada0 smartctl 7.3 2022-02-28 r5338 [FreeBSD 13.1-RELEASE-p7 amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: HGST Travelstar 5K1000 Device Model: HGST HTS541075A9E680 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JA2OA710 User Capacity: 750,156,374,016 bytes [750 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5319 ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Wed May 31 04:34:04 2023 EDT SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED See vendor-specific Attribute list for marginal Attributes. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x51) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 176) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 100 100 062 - 0 2 Throughput_Performance P-S--K 100 100 040 - 0 3 Spin_Up_Time PO---K 208 100 033 - 1 4 Start_Stop_Count -O--CK 098 098 000 - 3239 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate POSR-K 100 100 067 - 0 8 Seek_Time_Performance P-S--K 100 100 040 - 0 9 Power_On_Hours -O--CK 089 089 000 - 5187 10 Spin_Retry_Count PO--CK 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 2351 183 Runtime_Bad_Block -O--CK 100 100 000 - 0 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 60130394112 188 Command_Timeout -O--CK 100 100 000 - 65543 190 Airflow_Temperature_Cel -O---K 076 044 045 Past 24 (Min/Max 24/33) 191 G-Sense_Error_Rate -O--CK 088 088 000 - 3256 192 Power-Off_Retract_Count -O--CK 100 100 000 - 1114129 193 Load_Cycle_Count -O--CK 098 098 000 - 29768 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O--CK 100 100 000 - 0 198 Offline_Uncorrectable ----CK 100 100 000 - 0 199 UDMA_CRC_Error_Count -OS-CK 100 100 000 - 0 223 Load_Retry_Count -O-R-K 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 2927 - # 2 Short offline Completed without error 00% 2924 - # 3 Short offline Completed without error 00% 2924 - # 4 Short offline Completed without error 00% 1841 - # 5 Short offline Completed without error 00% 1658 - # 6 Short offline Completed without error 00% 1533 - # 7 Short offline Completed without error 00% 1409 - # 8 Short offline Interrupted (host reset) 40% 5 - # 9 Short offline Completed without error 00% 4 - #10 Short offline Completed without error 00% 4 - #11 Short offline Completed without error 00% 4 - #12 Short offline Completed without error 00% 3 - #13 Short offline Completed without error 00% 3 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 24 Celsius Power Cycle Min/Max Temperature: 24/33 Celsius Lifetime Min/Max Temperature: 4/56 Celsius Specified Max Operating Temperature: 28 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (31) Index Estimated Time Temperature Celsius 32 2023-05-31 02:27 31 ************ ... ..( 2 skipped). .. ************ 35 2023-05-31 02:30 31 ************ 36 2023-05-31 02:31 32 ************* 37 2023-05-31 02:32 31 ************ ... ..( 22 skipped). .. ************ 60 2023-05-31 02:55 31 ************ 61 2023-05-31 02:56 30 *********** 62 2023-05-31 02:57 30 *********** 63 2023-05-31 02:58 29 ********** 64 2023-05-31 02:59 29 ********** 65 2023-05-31 03:00 28 ********* ... ..( 2 skipped). .. ********* 68 2023-05-31 03:03 28 ********* 69 2023-05-31 03:04 27 ******** ... ..( 2 skipped). .. ******** 72 2023-05-31 03:07 27 ******** 73 2023-05-31 03:08 26 ******* ... ..( 23 skipped). .. ******* 97 2023-05-31 03:32 26 ******* 98 2023-05-31 03:33 25 ****** 99 2023-05-31 03:34 26 ******* ... ..( 5 skipped). .. ******* 105 2023-05-31 03:40 26 ******* 106 2023-05-31 03:41 25 ****** 107 2023-05-31 03:42 25 ****** 108 2023-05-31 03:43 26 ******* ... ..( 2 skipped). .. ******* 111 2023-05-31 03:46 26 ******* 112 2023-05-31 03:47 25 ****** 113 2023-05-31 03:48 25 ****** 114 2023-05-31 03:49 26 ******* 115 2023-05-31 03:50 26 ******* 116 2023-05-31 03:51 26 ******* 117 2023-05-31 03:52 25 ****** 118 2023-05-31 03:53 26 ******* ... ..( 18 skipped). .. ******* 9 2023-05-31 04:12 26 ******* 10 2023-05-31 04:13 25 ****** 11 2023-05-31 04:14 25 ****** 12 2023-05-31 04:15 26 ******* 13 2023-05-31 04:16 25 ****** 14 2023-05-31 04:17 25 ****** 15 2023-05-31 04:18 25 ****** 16 2023-05-31 04:19 26 ******* 17 2023-05-31 04:20 25 ****** ... ..( 5 skipped). .. ****** 23 2023-05-31 04:26 25 ****** 24 2023-05-31 04:27 24 ***** ... ..( 6 skipped). .. ***** 31 2023-05-31 04:34 24 ***** SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 8 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 9 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS