Probe #1034c9883a of Fujitsu D3313-A1 S26361-D331... Desktop Computer (FUTRO S920)

Log: smartctl

/dev/ada0 smartctl 7.4 2023-08-01 r5530 [FreeBSD 13.2-RELEASE-p5 amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Silicon Motion based SSDs Device Model: KINGSTON SKC600MS256G Serial Number: -- LU WWN Device Id: 5 0026b7 ... Firmware Version: S4800105 User Capacity: 256,060,514,304 bytes [256 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available, deterministic, zeroed Device is: In smartctl database 7.3/5528 ATA Version is: ACS-3 T13/2161-D revision 5 SATA Version is: SATA 3.3, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Dec 6 03:34:50 2023 +04 SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Unknown === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0002) Does not save SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 30) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x0031) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate ------ 100 100 000 - 0 5 Reallocated_Sector_Ct ------ 100 100 000 - 0 9 Power_On_Hours ------ 100 100 000 - 40 12 Power_Cycle_Count ------ 100 100 000 - 37 148 Total_SLC_Erase_Ct ------ 100 100 000 - 3 149 Max_SLC_Erase_Ct ------ 100 100 000 - 1 150 Min_SLC_Erase_Ct ------ 100 100 000 - 0 151 Average_SLC_Erase_Ct ------ 100 100 000 - 0 159 DRAM_1_Bit_Error_Count ------ 100 100 000 - 0 160 Uncorrectable_Error_Cnt ------ 100 100 000 - 0 161 Valid_Spare_Block_Cnt ------ 100 100 000 - 37 164 Total_Erase_Count ------ 100 100 000 - 170 165 Max_Erase_Count ------ 100 100 000 - 2 166 Min_Erase_Count ------ 100 100 000 - 0 167 Average_Erase_Count ------ 100 100 000 - 0 169 Remaining_Lifetime_Perc ------ 100 100 000 - 100 177 Wear_Leveling_Count ------ 100 100 050 - 0 181 Program_Fail_Cnt_Total ------ 100 100 000 - 0 182 Erase_Fail_Count_Total ------ 100 100 000 - 0 192 Power-Off_Retract_Count ------ 100 100 000 - 3 194 Temperature_Celsius ------ 054 059 000 - 54 195 Hardware_ECC_Recovered ------ 100 100 000 - 0 196 Reallocated_Event_Count ------ 100 100 016 - 0 199 UDMA_CRC_Error_Count ------ 100 100 050 - 0 231 SSD_Life_Left ------ 100 100 000 - 100 232 Available_Reservd_Space ------ 100 100 000 - 100 241 Host_Writes_32MiB ------ 100 100 000 - 656 242 Host_Reads_32MiB ------ 100 100 000 - 123 245 TLC_Writes_32MiB ------ 100 100 000 - 2805 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x04 GPL,SL R/O 8 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x24 GPL R/O 88 Current Device Internal Status Data log 0x25 GPL R/O 128 Saved Device Internal Status Data log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xd1 GPL,SL VS 128 Device vendor specific log 0xd2 GPL,SL VS 8 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Completed [00% left] (0-65535) Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 1 (0x0001) Device State: Active (0) Current Temperature: 54 Celsius Power Cycle Min/Max Temperature: 31/59 Celsius Lifetime Min/Max Temperature: 26/59 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/100 Celsius Min/Max Temperature Limit: 0/100 Celsius Temperature History Size (Index): 128 (29) Index Estimated Time Temperature Celsius 30 2023-12-06 01:27 56 ************************************* ... ..( 12 skipped). .. ************************************* 43 2023-12-06 01:40 56 ************************************* 44 2023-12-06 01:41 55 ************************************ 45 2023-12-06 01:42 56 ************************************* ... ..( 3 skipped). .. ************************************* 49 2023-12-06 01:46 56 ************************************* 50 2023-12-06 01:47 55 ************************************ 51 2023-12-06 01:48 56 ************************************* 52 2023-12-06 01:49 56 ************************************* 53 2023-12-06 01:50 55 ************************************ ... ..( 72 skipped). .. ************************************ 126 2023-12-06 03:03 55 ************************************ 127 2023-12-06 03:04 57 ************************************** 0 2023-12-06 03:05 57 ************************************** 1 2023-12-06 03:06 57 ************************************** 2 2023-12-06 03:07 56 ************************************* 3 2023-12-06 03:08 56 ************************************* 4 2023-12-06 03:09 55 ************************************ ... ..( 15 skipped). .. ************************************ 20 2023-12-06 03:25 55 ************************************ 21 2023-12-06 03:26 54 *********************************** ... ..( 7 skipped). .. *********************************** 29 2023-12-06 03:34 54 *********************************** SCT Error Recovery Control command not supported Device Statistics (GP Log 0x04) Page Offset Size Value Flags Description 0x01 ===== = = === == General Statistics (rev 1) == 0x01 0x008 4 37 --- Lifetime Power-On Resets 0x01 0x010 4 40 --- Power-on Hours 0x01 0x018 6 43045216 --- Logical Sectors Written 0x01 0x020 6 2146110 --- Number of Write Commands 0x01 0x028 6 8102958 --- Logical Sectors Read 0x01 0x030 6 297499 --- Number of Read Commands 0x01 0x038 6 144263987 --- Date and Time TimeStamp 0x04 ===== = = === == General Errors Statistics (rev 1) == 0x04 0x008 4 0 --- Number of Reported Uncorrectable Errors 0x04 0x010 4 3 --- Resets Between Cmd Acceptance and Completion 0x05 ===== = = === == Temperature Statistics (rev 1) == 0x05 0x008 1 54 --- Current Temperature 0x05 0x010 1 55 --- Average Short Term Temperature 0x05 0x018 1 55 --- Average Long Term Temperature 0x05 0x020 1 59 --- Highest Temperature 0x05 0x028 1 26 --- Lowest Temperature 0x05 0x030 1 55 --- Highest Average Short Term Temperature 0x05 0x038 1 0 --- Lowest Average Short Term Temperature 0x05 0x040 1 55 --- Highest Average Long Term Temperature 0x05 0x048 1 0 --- Lowest Average Long Term Temperature 0x05 0x050 4 0 --- Time in Over-Temperature 0x05 0x058 1 70 --- Specified Maximum Operating Temperature 0x05 0x060 4 0 --- Time in Under-Temperature 0x05 0x068 1 0 --- Specified Minimum Operating Temperature 0x06 ===== = = === == Transport Statistics (rev 1) == 0x06 0x008 4 138 --- Number of Hardware Resets 0x06 0x010 4 68 --- Number of ASR Events 0x06 0x018 4 0 --- Number of Interface CRC Errors 0x07 ===== = = === == Solid State Device Statistics (rev 1) == 0x07 0x008 1 0 --- Percentage Used Endurance Indicator |||_ C monitored condition met ||__ D supports DSN |___ N normalized value Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 29 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC


Hardware for Linux and BSD

GitHub