/dev/sd0 smartctl 7.3 2022-02-28 r5338 [OpenBSD 7.2 amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Apple SD/SM/TS...E/F/G SSDs Device Model: APPLE SSD SM0512G Serial Number: -- LU WWN Device Id: 5 002538 ... Firmware Version: BXZ13A0Q User Capacity: 500,277,790,720 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: Solid State Device TRIM Command: Available Device is: In smartctl database 7.3/5319 ATA Version is: ATA8-ACS T13/1699-D revision 4c SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Sun Apr 16 12:58:44 2023 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART Status not supported: Incomplete response, ATA output registers missing SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 10) minutes. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x001a 200 200 000 Old_age Always - 0 5 Reallocated_Sector_Ct 0x0033 100 100 000 Pre-fail Always - 0 9 Power_On_Hours 0x0032 093 093 000 Old_age Always - 30733 12 Power_Cycle_Count 0x0032 061 061 000 Old_age Always - 39123 169 Unknown_Apple_Attrib 0x0013 253 253 010 Pre-fail Always - 2890663987072 173 Wear_Leveling_Count 0x0032 168 168 100 Old_age Always - 3131094270744 174 Host_Reads_MiB 0x0022 099 099 000 Old_age Always - 193144828 175 Host_Writes_MiB 0x0022 099 099 000 Old_age Always - 201287113 192 Power-Off_Retract_Count 0x0012 099 099 000 Old_age Always - 143 194 Temperature_Celsius 0x0022 074 023 000 Old_age Always - 26 (Min/Max 13/77) 197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0 199 UDMA_CRC_Error_Count 0x001a 200 200 000 Old_age Always - 0 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] Warning! SMART Selective Self-Test Log Structure error: invalid SMART checksum. SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 255 0 65535 Read_scanning was never started Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. /dev/sd1 smartctl 7.3 2022-02-28 r5338 [OpenBSD 7.2 amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Vendor: SanDisk' Product: Cruzer Fit Revision: 1.00 Compliance: SPC-4 User Capacity: 61,983,424,512 bytes [61.9 GB] Logical block size: 512 bytes Serial number: -- Device type: disk Local Time is: Sun Apr 16 12:58:44 2023 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled Temperature Warning: Disabled or Not Supported === START OF READ SMART DATA SECTION === SMART Health Status: OK Current Drive Temperature: 0 C Drive Trip Temperature: 0 C Read defect list: asked for grown list but didn't get it Error Counter logging not supported Device does not support Self Test logging /dev/sd2 smartctl 7.3 2022-02-28 r5338 [OpenBSD 7.2 amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org Smartctl open device: /dev/sd2c failed: No medium found