/dev/ada0 smartctl 7.4 2023-08-01 r5530 [FreeBSD 14.0-RELEASE amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Samsung based SSDs Device Model: Samsung SSD 850 EVO 250GB Serial Number: -- LU WWN Device Id: 5 002538 ... Firmware Version: EMT03B6Q User Capacity: 250,059,350,016 bytes [250 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available Device is: In smartctl database 7.3/5528 ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4c SATA Version is: SATA 3.1, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Wed Nov 22 17:08:51 2023 MST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 133) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 9 Power_On_Hours -O--CK 099 099 000 - 12 12 Power_Cycle_Count -O--CK 099 099 000 - 16 177 Wear_Leveling_Count PO--C- 100 100 000 - 0 179 Used_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 0 181 Program_Fail_Cnt_Total -O--CK 100 100 010 - 0 182 Erase_Fail_Count_Total -O--CK 100 100 010 - 0 183 Runtime_Bad_Block PO--C- 100 100 010 - 0 187 Uncorrectable_Error_Cnt -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O--CK 054 054 000 - 46 195 ECC_Error_Rate -O-RC- 200 200 000 - 0 199 CRC_Error_Count -OSRCK 100 100 000 - 0 235 POR_Recovery_Count -O--C- 099 099 000 - 10 241 Total_LBAs_Written -O--CK 099 099 000 - 41972528 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa1 SL VS 16 Device vendor specific log 0xa5 SL VS 16 Device vendor specific log 0xce SL VS 16 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 255 0 65535 Read_scanning was never started Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 45 Celsius Power Cycle Min/Max Temperature: 32/45 Celsius Lifetime Min/Max Temperature: 25/45 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 10 minutes Min/Max recommended Temperature: 0/70 Celsius Min/Max Temperature Limit: 0/70 Celsius Temperature History Size (Index): 128 (98) Index Estimated Time Temperature Celsius 99 2023-11-21 19:50 ? - ... ..( 27 skipped). .. - 127 2023-11-22 00:30 ? - 0 2023-11-22 00:40 40 ********************* 1 2023-11-22 00:50 ? - ... ..( 9 skipped). .. - 11 2023-11-22 02:30 ? - 12 2023-11-22 02:40 28 ********* 13 2023-11-22 02:50 31 ************ 14 2023-11-22 03:00 34 *************** 15 2023-11-22 03:10 35 **************** 16 2023-11-22 03:20 36 ***************** 17 2023-11-22 03:30 36 ***************** 18 2023-11-22 03:40 36 ***************** 19 2023-11-22 03:50 42 *********************** 20 2023-11-22 04:00 44 ************************* 21 2023-11-22 04:10 ? - 22 2023-11-22 04:20 34 *************** 23 2023-11-22 04:30 31 ************ 24 2023-11-22 04:40 30 *********** 25 2023-11-22 04:50 29 ********** 26 2023-11-22 05:00 29 ********** 27 2023-11-22 05:10 29 ********** 28 2023-11-22 05:20 28 ********* 29 2023-11-22 05:30 ? - 30 2023-11-22 05:40 ? - 31 2023-11-22 05:50 ? - 32 2023-11-22 06:00 25 ****** 33 2023-11-22 06:10 26 ******* 34 2023-11-22 06:20 ? - 35 2023-11-22 06:30 ? - 36 2023-11-22 06:40 25 ****** 37 2023-11-22 06:50 27 ******** 38 2023-11-22 07:00 26 ******* 39 2023-11-22 07:10 27 ******** 40 2023-11-22 07:20 27 ******** 41 2023-11-22 07:30 ? - 42 2023-11-22 07:40 28 ********* 43 2023-11-22 07:50 27 ******** 44 2023-11-22 08:00 28 ********* 45 2023-11-22 08:10 28 ********* 46 2023-11-22 08:20 ? - 47 2023-11-22 08:30 28 ********* 48 2023-11-22 08:40 28 ********* 49 2023-11-22 08:50 ? - 50 2023-11-22 09:00 29 ********** 51 2023-11-22 09:10 29 ********** 52 2023-11-22 09:20 ? - 53 2023-11-22 09:30 ? - 54 2023-11-22 09:40 ? - 55 2023-11-22 09:50 27 ******** 56 2023-11-22 10:00 35 **************** 57 2023-11-22 10:10 34 *************** 58 2023-11-22 10:20 34 *************** 59 2023-11-22 10:30 35 **************** 60 2023-11-22 10:40 36 ***************** 61 2023-11-22 10:50 35 **************** 62 2023-11-22 11:00 35 **************** 63 2023-11-22 11:10 36 ***************** ... ..( 8 skipped). .. ***************** 72 2023-11-22 12:40 36 ***************** 73 2023-11-22 12:50 37 ****************** ... ..( 10 skipped). .. ****************** 84 2023-11-22 14:40 37 ****************** 85 2023-11-22 14:50 36 ***************** 86 2023-11-22 15:00 ? - 87 2023-11-22 15:10 ? - 88 2023-11-22 15:20 32 ************* 89 2023-11-22 15:30 ? - 90 2023-11-22 15:40 38 ******************* 91 2023-11-22 15:50 42 *********************** 92 2023-11-22 16:00 44 ************************* 93 2023-11-22 16:10 45 ************************** 94 2023-11-22 16:20 45 ************************** 95 2023-11-22 16:30 45 ************************** 96 2023-11-22 16:40 44 ************************* 97 2023-11-22 16:50 45 ************************** 98 2023-11-22 17:00 45 ************************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 7 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 6 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC