/dev/ada0 smartctl 7.3 2022-02-28 r5338 [FreeBSD 14.0-CURRENT amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: HGST Travelstar 7K1000 Device Model: HGST HTS721010A9E630 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JB0OA3T0 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5319 ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Jun 28 08:09:55 2023 BST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED See vendor-specific Attribute list for marginal Attributes. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x51) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 170) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 100 077 062 - 0 2 Throughput_Performance P-S--K 100 100 040 - 0 3 Spin_Up_Time PO---K 124 100 033 - 2 4 Start_Stop_Count -O--CK 099 099 000 - 1919 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate POSR-K 100 100 067 - 0 8 Seek_Time_Performance P-S--K 100 100 040 - 0 9 Power_On_Hours -O--CK 032 032 000 - 30144 10 Spin_Retry_Count PO--CK 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 1914 183 Runtime_Bad_Block -O--CK 100 100 000 - 0 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 146029346816 188 Command_Timeout -O--CK 100 100 000 - 12886802434 190 Airflow_Temperature_Cel -O---K 057 042 045 Past 43 (Min/Max 32/47) 191 G-Sense_Error_Rate -O--CK 096 096 000 - 1096 192 Power-Off_Retract_Count -O--CK 100 100 000 - 5374034 193 Load_Cycle_Count -O--CK 079 079 000 - 213178 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O--CK 100 100 000 - 0 198 Offline_Uncorrectable ----CK 100 100 000 - 0 199 UDMA_CRC_Error_Count -OS-CK 100 100 000 - 0 223 Load_Retry_Count -O-R-K 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 28097 - # 2 Short offline Completed without error 00% 20932 - # 3 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 43 Celsius Power Cycle Min/Max Temperature: 32/47 Celsius Lifetime Min/Max Temperature: 6/58 Celsius Specified Max Operating Temperature: 36 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (78) Index Estimated Time Temperature Celsius 79 2023-06-28 06:02 43 ************************ ... ..( 3 skipped). .. ************************ 83 2023-06-28 06:06 43 ************************ 84 2023-06-28 06:07 42 *********************** ... ..( 33 skipped). .. *********************** 118 2023-06-28 06:41 42 *********************** 119 2023-06-28 06:42 41 ********************** 120 2023-06-28 06:43 42 *********************** 121 2023-06-28 06:44 41 ********************** ... ..( 2 skipped). .. ********************** 124 2023-06-28 06:47 41 ********************** 125 2023-06-28 06:48 42 *********************** ... ..( 2 skipped). .. *********************** 0 2023-06-28 06:51 42 *********************** 1 2023-06-28 06:52 41 ********************** 2 2023-06-28 06:53 41 ********************** 3 2023-06-28 06:54 41 ********************** 4 2023-06-28 06:55 42 *********************** 5 2023-06-28 06:56 41 ********************** 6 2023-06-28 06:57 42 *********************** 7 2023-06-28 06:58 41 ********************** 8 2023-06-28 06:59 42 *********************** 9 2023-06-28 07:00 41 ********************** 10 2023-06-28 07:01 41 ********************** 11 2023-06-28 07:02 41 ********************** 12 2023-06-28 07:03 42 *********************** 13 2023-06-28 07:04 41 ********************** ... ..( 30 skipped). .. ********************** 44 2023-06-28 07:35 41 ********************** 45 2023-06-28 07:36 42 *********************** 46 2023-06-28 07:37 41 ********************** ... ..( 3 skipped). .. ********************** 50 2023-06-28 07:41 41 ********************** 51 2023-06-28 07:42 42 *********************** ... ..( 12 skipped). .. *********************** 64 2023-06-28 07:55 42 *********************** 65 2023-06-28 07:56 43 ************************ 66 2023-06-28 07:57 42 *********************** 67 2023-06-28 07:58 42 *********************** 68 2023-06-28 07:59 42 *********************** 69 2023-06-28 08:00 43 ************************ ... ..( 8 skipped). .. ************************ 78 2023-06-28 08:09 43 ************************ SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 4 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 1 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS