/dev/sd0c smartctl 7.2 2020-12-30 r5155 [OpenBSD 7.0 amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: Netac SSD 240GB Serial Number: -- LU WWN Device Id: 0 000000 ... Firmware Version: FW200326 User Capacity: 240,057,409,536 bytes [240 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ACS-2 T13/2015-D revision 3 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon Dec 13 19:18:42 2021 CST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART Status not supported: Incomplete response, ATA output registers missing SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x5d) SMART execute Offline immediate. No Auto Offline data collection support. Abort Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0002) Does not save SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 4) minutes. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x0032 100 100 050 Old_age Always - 0 5 Reallocated_Sector_Ct 0x0032 100 100 050 Old_age Always - 0 9 Power_On_Hours 0x0032 100 100 050 Old_age Always - 292 12 Power_Cycle_Count 0x0032 100 100 050 Old_age Always - 264 160 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 0 161 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 0 163 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 284 164 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 10903 165 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 41 166 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 1 167 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 13 168 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 0 169 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 0 175 Program_Fail_Count_Chip 0x0032 100 100 050 Old_age Always - 83886080 176 Erase_Fail_Count_Chip 0x0032 100 100 050 Old_age Always - 157555 177 Wear_Leveling_Count 0x0032 100 100 050 Old_age Always - 174110 178 Used_Rsvd_Blk_Cnt_Chip 0x0032 100 100 050 Old_age Always - 0 181 Program_Fail_Cnt_Total 0x0032 100 100 050 Old_age Always - 0 182 Erase_Fail_Count_Total 0x0032 100 100 050 Old_age Always - 0 192 Power-Off_Retract_Count 0x0032 100 100 050 Old_age Always - 32 194 Temperature_Celsius 0x0032 100 100 050 Old_age Always - 40 195 Hardware_ECC_Recovered 0x0032 100 100 050 Old_age Always - 5435 196 Reallocated_Event_Count 0x0032 100 100 050 Old_age Always - 0 197 Current_Pending_Sector 0x0032 100 100 050 Old_age Always - 0 198 Offline_Uncorrectable 0x0032 100 100 050 Old_age Always - 0 199 UDMA_CRC_Error_Count 0x0032 100 100 050 Old_age Always - 1 232 Available_Reservd_Space 0x0032 100 100 050 Old_age Always - 0 241 Total_LBAs_Written 0x0032 100 100 050 Old_age Always - 11215 242 Total_LBAs_Read 0x0032 100 100 050 Old_age Always - 4583 249 Unknown_Attribute 0x0032 100 100 050 Old_age Always - 12871 SMART Error Log Version: 0 No Errors Logged SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Offline Completed without error 00% 24 - # 2 Offline Self-test routine in progress 10% 24 - # 3 Offline Self-test routine in progress 10% 24 - # 4 Offline Self-test routine in progress 10% 24 - # 5 Offline Self-test routine in progress 10% 24 - # 6 Offline Self-test routine in progress 10% 24 - # 7 Offline Self-test routine in progress 10% 24 - # 8 Offline Self-test routine in progress 10% 24 - # 9 Offline Self-test routine in progress 10% 24 - #10 Offline Self-test routine in progress 10% 24 - #11 Offline Self-test routine in progress 10% 24 - #12 Offline Self-test routine in progress 10% 24 - #13 Offline Self-test routine in progress 10% 24 - #14 Offline Self-test routine in progress 10% 24 - #15 Offline Self-test routine in progress 10% 24 - #16 Offline Self-test routine in progress 10% 24 - #17 Offline Self-test routine in progress 10% 24 - #18 Offline Self-test routine in progress 10% 24 - #19 Offline Self-test routine in progress 10% 24 - #20 Offline Self-test routine in progress 10% 24 - #21 Offline Self-test routine in progress 10% 24 - SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. /dev/sd1c smartctl 7.2 2020-12-30 r5155 [OpenBSD 7.0 amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Plextor M3/M5/M6/M7 Series SSDs Device Model: PLEXTOR PX-128M6S Serial Number: -- LU WWN Device Id: 5 002303 ... Add. Product Id: HC7020R0 Firmware Version: 1.08 User Capacity: 128,035,676,160 bytes [128 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device TRIM Command: Available Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS, ATA/ATAPI-7 T13/1532D revision 4a SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon Dec 13 19:18:42 2021 CST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART Status not supported: Incomplete response, ATA output registers missing SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 10) seconds. Offline data collection capabilities: (0x15) SMART execute Offline immediate. No Auto Offline data collection support. Abort Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. No Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 10) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 100 100 000 Pre-fail Always - 0 5 Reallocated_Sector_Ct 0x0003 100 100 000 Pre-fail Always - 0 9 Power_On_Hours 0x0002 100 100 000 Old_age Always - 2398 12 Power_Cycle_Count 0x0003 100 100 000 Pre-fail Always - 2906 170 Unknown_Plextor_Attrib 0x0032 100 100 000 Old_age Always - 0 171 Unknown_Plextor_Attrib 0x0003 100 100 000 Pre-fail Always - 0 172 Unknown_Plextor_Attrib 0x0003 100 100 000 Pre-fail Always - 0 173 Unknown_Plextor_Attrib 0x0003 100 100 000 Pre-fail Always - 76 174 Unknown_Plextor_Attrib 0x0003 100 100 000 Pre-fail Always - 868 175 Program_Fail_Count_Chip 0x0003 100 100 000 Pre-fail Always - 0 176 Erase_Fail_Count_Chip 0x0003 100 100 000 Pre-fail Always - 0 177 Wear_Leveling_Count 0x0003 100 100 000 Pre-fail Always - 78143 178 Used_Rsvd_Blk_Cnt_Chip 0x0003 100 100 000 Pre-fail Always - 0 179 Used_Rsvd_Blk_Cnt_Tot 0x0003 100 100 000 Pre-fail Always - 0 180 Unused_Rsvd_Blk_Cnt_Tot 0x0033 100 100 000 Pre-fail Always - 1072 181 Program_Fail_Cnt_Total 0x0003 100 100 000 Pre-fail Always - 0 182 Erase_Fail_Count_Total 0x0003 100 100 000 Pre-fail Always - 0 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0 184 End-to-End_Error 0x0033 100 100 000 Pre-fail Always - 0 187 Reported_Uncorrect 0x0003 100 100 000 Pre-fail Always - 0 188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0 192 Power-Off_Retract_Count 0x0003 100 100 000 Pre-fail Always - 868 195 Hardware_ECC_Recovered 0x0003 100 100 000 Pre-fail Always - 0 196 Reallocated_Event_Count 0x0003 100 100 000 Pre-fail Always - 0 198 Offline_Uncorrectable 0x0003 100 100 000 Pre-fail Always - 0 199 UDMA_CRC_Error_Count 0x0003 100 100 000 Pre-fail Always - 0 232 Available_Reservd_Space 0x0003 100 100 010 Pre-fail Always - 0 233 Media_Wearout_Indicator 0x0003 100 100 000 Pre-fail Always - 9568 241 Host_Writes_32MiB 0x0003 100 100 000 Pre-fail Always - 153092 242 Host_Reads_32MiB 0x0003 100 100 000 Pre-fail Always - 129066 SMART Error Log Version: 0 No Errors Logged SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] Selective Self-tests/Logging not supported